Kerio-tech Firewall6 Manuel d'utilisateur télécharger pdf (Page 235)

100

101

18.1 Routing table

235

Deﬁnitions of Dynamic and Static Rules

Click on the Add (or Edit when a particular route is selected) button to display a dialog for

route deﬁnition.

Figure 18.2 Adding a route to the routing table

Network, Network Mask

IP address and mask of the destination network.

Interface

Selection of an interface through which the speciﬁc packet should be forwarded.

Gateway

IP address of the gateway (router) which can route to the destination network. The IP

address of the gateway must be in the same IP subnet as the selected interface.

Metric

“Distance” of the destination network. The number stands for the number of routers that

a packet must pass through to reach the destination network.

Metric is used to ﬁnd the best route to the desired network. The lower the metric value,

the “shorter” the route is.

Note: Metric in the routing table may diﬀer from the real network topology. It may be

modiﬁed according to the priority of each line, etc.

Create a static route

Enable this option to make this route static. Such route will be restored automatically by

WinRoute(see above). A brief description providing various information (why the route

was created, etc.) about the route can be attached.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 403 404

Commentaires sur ces manuels

Pas de commentaire

Kerio-tech Firewall6 Manuel d'utilisateur Page 235

Commentaires sur ces manuels